This new li-po battery (LP-0043) is specifically developed for all 1/10 explosive RC cars. It makes the cars perform speedy! Most of the RC drivers comment it is a MUST buy item especially for the competition! The process of installation is very simple and time-saving which applies to all RC cars. Just strengthen your car with this powerful li-po battery!
Feature:
For: Split-Type Battery Mount (Tamiya 501X , Hotbodies D4, Xpress)
Specification:
Discharge rate: 20C
Capacity: 5000mAh
Cells : Split-Type 2cells
Voltage:7.4v
Length: 70mm
Width: 43mm
Height: 24mm
Net: 277g
Why go Li-Po
Runtime up to 30% longer than traditional NiMH/NiCd (of the same capacity).
Weight up to 40% lighter than traditional NiMH/NiCd (of the same capacity).
Li-Po power delivery ensures maximum power throughout the discharge cycle.
Less internal resistance offered by advanced cell fusion technology.
Less energy lost in form of heat makes a greater power output.
Complicated maintenance-free or conditioning-free.
Balancing port included.
Compatibles 90% of 1/10 scale chassis with little or zero modification.
Can be used and recharged unlimited times per session.
Less cost over time as longer lifespan up to 10 times that of NiMH/NiCd.
Sealed case makes perfect for tracks looking.
Caution:
For your safety, please read the instruction before use.
Click the icon below to download.
PDF
Datasheet
In addition, please make sure that other series of Li-Po Battery Pack within the positive and negative sides or wires are certainly correct before using. You are welcome to inquire us about the subject.
Battery Charging:
Users should charge the battery within 0.5C rate for the first 8 to 10 sequences.
Subsequently, 1C rate charging is good to maintain the lifespan of battery.
Of course, users may use higher C rate to charge but it will affect the battery performance even life cycle is still short.
Therefore, we recommend all users should follow the above instruction of battery charging.
